Watch Protection Installation Guide

Follow these easy steps to protect your watch with WATCH PROTECTIVE Watch Protection Film

Important: Our adhesive is water-activated. Keep both the watch surface and the adhesive side of the film wet during placement.

1) Prep & Clean

Work in a clean, dust-free area with good light.
Wipe bezel, case edges, clasp, and bracelet contact points until dust-free, oil-free, and dry.

2) Peel & Handle with care

  • Peel from the liner holding only the edges.
  • Avoid touching the adhesive; keep dust away from the sticky side.

3) Wet & Activate

  • Fully wet the adhesive side of the film (you may dip the piece in a cup of water).
  • Ensure every part of the adhesive has contacted water.
  • No soap or additives required.

4) Place & Align Precisely

  • Float the wet film into position.
  • Align so all edges sit just inside the part boundary (no overhang).
  • Precise placement helps prevent early lifting/peeling.

5) Cure

  • Pat dry and set the watch aside. Do not wear for 48 hours.
  • During curing, water spots, faint marks, slight haze, or tiny bubbles typically dissipate on their own.


Need help choosing the right kit or have install questions?

Contact us or email us at hello@watchprotective.com.